What did you reload today.

Joined
March 24, 2013
Messages
999
Likes
32
#41
.44 mag .250 grain SWC over 20.3 grains of IMR 4227 over CCI 350 primers. Not a max load by any means but a good starting load for ladder test. I'll go up from here as I have a lot of IMR 4227.
 
Joined
March 24, 2013
Messages
999
Likes
32
#42
Went to the range today and shot that load. so today I bumped it up a 1 grain I'm hoping to find the sweet spot. I'll clean the bore and sex up the gun with a good cleaning. John Taffin's load for 245 grain cast was 24 grains of powder with a gas check. But like a lot of reloaders I'll work this out. I've have a little leading in the barrel from some earlier shooting. There is no muzzle blast with a fire ball and recoil is mild. In the morning I will bump the round and again. So first load was 20.3 - 21.3 - 22.3 - 23.3. Any thoughts from any of you.:flag:
 
Joined
March 24, 2013
Messages
999
Likes
32
#43
Reloading during the Holidays again the reloading press was in action. My cast bullet supply is getting low the CCI MAG primers are low but the bullets are stacking up. So all is good in my world. I'm off for 6 days and with a little time and patience on the wife's part I should get half my brass loaded.
 
Joined
March 24, 2013
Messages
999
Likes
32
#46
Well today I was in the reloading/gunroom. The press and myself were running smooth. I'm starting with The 22k Hornet brass and then will move on to the other calibers. Boy those small calibers bullets are a pain but steady always wins over speed.:):flag:
 
Joined
December 23, 2012
Messages
797
Likes
35
#47
Maybe someday I'll get back to reloading.
-need to make up 223 test loads for an AR.
-need to make up 223 test loads for a Rem 700.
-need to make up 300AAc test loads for Ruger bolt action.
-need to make 35Rem plinking range loads.
-need to make up 380acp test loads.
-9mm needs to be replenished.
-38 special needs to be replenished.
-357 Magnum needs to be replenished.
-40S&W needs to be replenished.
-10mm supply OK.
-41 Magnum needs some test loads.
-44 Magnum supply OK.
-44 Special needs some test loads.

-S&W M610 10mm revolver project; use 30-30 brass to make rimmed 10mm cartridges so that the revolver can be loaded like a regular revolver and not have to use moon clips.

Yes,I've got reloading to do !!! Don't need any components,have brass,primers,powder,bullets for all the above.
 
Joined
March 24, 2013
Messages
999
Likes
32
#52
Well I loaded the last of the 240 grain Hornady XTP. Back a few years ago got 1000 free when I bought my press. The load not max but 23.0 grains of H110 over a mag CCI 350 primer. :):flag::flag: